R Series (AD/DA): Generasi ke-3 - Spesifikasi - Antarmuka - Produk - Audio - Yamaha - Business

Dapat digulir

			Rio3224-D3	Rio1608-D3
Spesifikasi Umum	Sampling frequency rate	Eksternal	44,1 kHz, 48 kHz, 88,2 kHz, 96 kHz, +4,1667%, +0,1%, –0,1%, –4,0% (±200 ppm)	44,1 kHz, 48 kHz, 88,2 kHz, 96 kHz, +4,1667%, +0,1%, –0,1%, –4,0% (±200 ppm)
	Signal delay		kurang dari 1,7 ms, INPUT Rio-D3 ke OUTPUT Rio-D3 terhubung dengan DM7 menggunakan Dante, Fs = 96 kHz. Dante Receive Latency diatur ke 0,25 milidetik	kurang dari 1,7 ms, INPUT Rio-D3 ke OUTPUT Rio-D3 terhubung dengan DM7 menggunakan Dante, Fs = 96 kHz. Dante Receive Latency diatur ke 0,25 milidetik
	Total harmonic distortion		Kurang dari 0,05% +4 dBu@20 Hz - 20 kHz, GAIN : -6 dB ke 600 Ω, Kurang dari 0,15% +4 dBu@20 Hz - 20 kHz, GAIN: +66 dB ke 600 Ω	Kurang dari 0,05% +4 dBu@20 Hz - 20 kHz, GAIN: -6 dB pada 600 Ω, Kurang dari 0,15% +4 dBu@20 Hz - 20 kHz, GAIN: +66 dB pada 600 Ω
	Frequency response		+0.5, –1.5 dB 20 Hz - 20 kHz, mengacu pada output +4 dBu @1 kHz, input ke output, Fs= 48 kHz atau 96 kHz	+0.5, –1.5 dB 20 Hz - 20 kHz, mengacu pada output +4 dBu @1 kHz, input ke output, Fs= 48 kHz atau 96 kHz
	Dynamic Range		120 dB typ., Konverter DA, 115 dB typ, Input ke Output, GAIN: -6 dB	120 dB typ., Konverter DA, 115 dB typ, Input ke Output, GAIN: -6 dB
	Hum & noise level	Equivalent input noise	-128 dBu typ., GAIN: +66 dB	-128 dBu typ., GAIN: +66 dB
	Hum & noise level	Residual output noise	-93 dBu, channel stereo utama mati	-93 dBu, channel stereo utama mati
	Crosstalk		INPUT: -100 dB, input yang berdekatan, GAIN: -6 dB, @1 kHz, OUTPUT: -100 dB, input ke output, @1 kHz	INPUT: -100 dB, input yang berdekatan, GAIN: -6 dB, @1 kHz, OUTPUT: -100 dB, input ke output, @1 kHz
	Persyaratan daya		100 - 240 V, 50/60 Hz	100 - 240 V, 50/60 Hz
	Konsumsi daya		100 W	60 W
	Dimensi	P	480 mm (18,9")	480 mm (18,9")
		T	220 mm (8,7")	132 mm (5,2")
		L	370 mm (14,6”)	370 mm (14,6”)
	Berat Bersih		13,2 kg (29,1 lb)	9,4 kg (20,7 lb)
	Aksesori		Panduan Pemilik, Kabel daya AC×2, Lisensi Perangkat Lunak Open-Source	Panduan Pemilik, Kabel daya AC×2, Lisensi Perangkat Lunak Open-Source
	Lain-lain		Nilai NC: Kecepatan Kipas LOW: NC=20 / HIGH: NC=30 (Posisi pengukuran: 1 m dari depan unit), Kisaran suhu pengoperasian: 0 - 40 ° C, Kisaran suhu penyimpanan: -20 - 60 ° C	Nilai NC: Kecepatan Kipas LOW: NC=15 / HIGH: NC=25 (Posisi pengukuran: 1 m dari depan unit), Kisaran suhu pengoperasian: 0 - 40 ° C, Kisaran suhu penyimpanan: -20 - 60 ° C

Total Harmonic Distortion diukur dengan filter 18 dB/oktaf @80 kHz.

Hum & Noise diukur dengan filter A-Weight.

Crosstalk diukur dengan filter 30 dB/oktaf @22 kHz

Temukan Produk Serupa

Analog Input Characteristics

Input Terminals	GAIN	Actual Load Impedance	For Use With Nominal	Input Level			Connector
Input Terminals	GAIN	Actual Load Impedance	For Use With Nominal	Sensitivity*1	Nominal	Max. before clip	Connector
INPUT 1-32 (1-16)	+66 dB	7.5 kΩ	50-600 Ω Mics & 600 Ω Lines	–82 dBu (0.062 mV)	-62 dBu (0.616 mV)	-42 dBu (6.16 mV)	XLR 3-hole chassis (Balanced)^*2
INPUT 1-32 (1-16)	-6 dB	7.5 kΩ	50-600 Ω Mics & 600 Ω Lines	–10 dBu (245 mV)	+10 dBu (2.45 V)	+30 dBu (24.5 V)	XLR 3-hole chassis (Balanced)^*2

0 dBu = 0.775 Vrms.
+48 V DC (phantom power) is supplied to the [INPUT] 1-32 (1-16) connectors via each individual software-controlled switch.
*1. Sensitivity is the minimum level needed to output +4 dBu (1.23 V) or the specified level when the gain is set to maximum. (All faders and level controls are set to maximum.)
*2. 1=GND, 2=HOT, 3=COLD

Analog Output Characteristics

Output Terminals	Actual Source Impedance	For Use With Nominal	Output Level^*1		Connector
Output Terminals	Actual Source Impedance	For Use With Nominal	Nominal	Max. before clip	Connector
OUTPUT 1-16 (1-8)	75 Ω	600 Ω Lines	+4 dBu (1.23 mV)	+24 dBu (12.3 mV)	XLR 3-pin chassis (Balanced)^*2
PHONES	10 Ω	8 Ω Lines	60 mW*3	60 mW	TRS PHONE (6.3 mm) (STEREO PHONE) (Unbalanced)
PHONES	10 Ω	40 Ω Lines	60 mW*4	100 mW	TRS PHONE (6.3 mm) (STEREO PHONE) (Unbalanced)

0 dBu = 0.775 Vrms.
*1. You can change the output level for the [OUTPUT +4dBu] 1-16 (1-8) connectors. Contact your Yamaha dealer.
*2. 1=GND, 2=HOT, 3=COLD
*3. The [PHONES] level knob is set to 12 dB below maximum.
*4. The [PHONES] level knob is set to 10 dB below maximum.

Digital Input & Output Characteristics

Terminals	Format	Data Length	Level	Audio	Connector
PRIMARY/SECONDARY	Dante	24-bit or 32-bit	1000BASE-T	32ch (Rio3224-D3 to other devices) 26ch (Other devices to Rio3224-D3)	etherCON CAT5e
PRIMARY/SECONDARY	Dante	24-bit or 32-bit	1000BASE-T	16ch (Rio1608-D3 to other devices) 10ch (Other devices to Rio1608-D3)	etherCON CAT5e
AES/EBU 1/2, 3/4, 5/6, 7/8*1	AES/EBU Professional use	24-bit	RS422	2ch output	XLR 3-pin chassis (Balanced)*2

*1. Implemented only on the Rio3224-D3.
*2. 1=GND, 2=HOT, 3=COLD

Control I/O Standards

Terminals		Format	Connector
NETWORK	IEEE802.3	1000BASE-T/100BASE-TX	RJ-45

Use STP cables for connections.